Table of Contents
Fractal R6 GPU replacement
The Fractal Define R6 is a hugely versatile case and installing additional devices is fairly easy and straight forward. In this article we will cover removal and installation of your video card. As always, if you have any questions please don’t hesitate to reach out to the Puget Systems support department, we are here to help. Enjoy!
Below is a video detailing the process and below that are written steps.
Remove GPU
This section will cover the removal of a video card on your Puget System
Step 1:
Start by grounding yourself
Step 2:
Remove all power going into your system and orient yourself from the rear of the system
Step 3:
Remove the 2 thumb screws securing right hand side panel then slide panel off chassis
Step 4:
Locate the video card and remove the power cables going into it
Step 5:
Remove the bracing that is holding the video card in place
Step 6:
Remove the two thumb screws securing the video card into the case
Step 7:
With the screws removed we can now release the PCIe latch that holds the video card in the motherboard then pull the video card away from the motherboard and remove from the system
Step 8:
With the card removed we can remove the bracing screwed into the rear of the video card
Step 9:
Now we attach the bracing to the new card and proceed to "Install GPU into system"
Install GPU into system
This section will cover the installation of your new or replacement video card in the Fractal Define R6.
Step 1:
Secure the bracing onto the rear of the new video card
Step 2:
Slot the video card back into the PCIe slot being mindful of angles and bracing locations
Step 3:
Line up the video card into the case and firmly push to secure in motherboard so the PCIe latch is engaged
Step 4:
Screw the bracing back in then screw in the 2 thumb screws securing the video card to the rear of the chassis
Step 5:
Plug the power cables back into the video card
Step 6:
Return the side panel to the side of the case
Step 7:
Secure the side panel by screwing the 2 thumb screws into the rear of the case
Step 8:
Plug the PSU power back in and connect any other cables
Step 9:
Now patt yourself on the back because you just replaced your video card!
Need help with your Puget Systems PC?
If something is wrong with your Puget Systems PC, we are readily accessible, and our support team comes from a wide range of technological backgrounds to better assist you!
Looking for more support guides?
If you are looking for a solution to a problem you are having with your PC, we also have a number of other support guides that may be able to assist you with other issues.